2003 - 2008 Toyota Sequoia Back Door Power Window Inoperative

2003 - 2008 Toyota Sequoia Back Door Power Window Inoperative Some 2001 – 2006 model year Sequoia vehicles may experience a condition where the back door power window of the vehicle is inoperative/stuck in the closed position. The following procedure has been developed to address this condition.

Repair Procedure

1. Disconnect the negative (–) terminal of the vehicle battery.

2. Open the back door and leave open.

3. Using the plastic pry tool, remove the back door garnish center.

4. Using the plastic pry tool, remove the left and right back door side garnish panels.

5. Remove the strap cover, bolt, and pull strap.

6. Remove the back door trim board.

A. Insert the plastic pry tool between the back door trim board to release the clips retaining the back door trim.

B. Release each clip as shown in the illustration.

7. Disconnect both connectors to the back door ECU and both clips holding the wire harness to the large service cover. Download File PDF


Close Menu