2004 Acura MDX Brake System Bleeding

2004 Acura MDX Brake System Bleeding

NOTE:

 Do not reuse the drained fluid. Use only clean ACURA DOT 3 Brake Fluid from an unopened container. Using a non-Acura brake fluid can cause corrosion and shorten the life of the system.

 Do not mix different brands of brake fluid; they may not be compatible.

 Make sure no dirt or other foreign matter is allowed to contaminates the brake fluid.

 Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

 The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of the bleeding procedure and checked after bleeding each brake caliper. Add fluid as required.

1. Make sure the brake fluid level in the reservoir is at the MAX (upper) level line (A).

2. Slide a piece of clear plastic hose over the first bleed screw, and submerge the other end in a container of new brake fluid.

3. Have someone slowly pump the brake pedal several times, then apply steady pressure.

4. Loosen the left-front brake bleed screw to allow air to escape from the system. Then tighten the bleed screw securely.

5. Repeat the procedure for each wheel in the sequence shown following until air bubbles no longer appear in the fluid.

6. Refill the master cylinder reservoir to the MAX (upper) level line. Download File PDF


Close Menu