2009 Chevrolet Cobalt 2-Way Remote Start and Door Lock Transmitter Package Installation

2009 Chevrolet Cobalt 2-Way Remote Start and Door Lock Transmitter Package Installation

Procedure

1. If the vehicle is equipped with the tire pressure monitoring system (TPMS), use the scan tool to perform the copy and paste TPM Information procedure. This will extract the TPM tire type information as well as the sensor data from the existing RCDLR prior to its replacement and store this information in the scan tool. After RCDLR replacement, the tire type and sensor data stored in the scan tool is written to the new RCDLR, negating the need to perform the tire type setup and sensor learn procedure. This must be performed BEFORE removing the old RCDLR. Refer to Remote Control Door Lock Receiver Programming and Setup.

2. Physically replace the factory remote control door lock receiver (RCDLR) with the 2-Way RCDLR included in the kit. Refer to Remote Control Door Lock Receiver Replacement. Do not program or reassemble yet.

3. Lower the front of the headliner to access the antenna cable routing path. Refer to Headlining Trim Panel Replacement.

4. Remove the wiring cover for the rear view mirror, if equipped. It will not be reinstalled.

5. Clean the inside of the windshield above the rear view mirror where the antenna will be mounted with a surface cleaner (50 percent isopropyl alcohol, FS-1082 hi-flash naphtha or equivalent).

6. Dry the glass thoroughly using a lint-free cloth.

7. Apply Glass Adhesion Promoter GM P/N 12378555 (Canadian P/N 88901239) to the windshield in the area where you will install the antenna. Download File PDF


Close Menu