Home Auto Repair Intake Manifold Removal and Installation Acura MDX 2003 – Instructions

Intake Manifold Removal and Installation Acura MDX 2003 – Instructions

93
Download Exploded View Removal 1. Remove the intake manifold cover. 2. Disconnect the intake air temperature (IAT) sensor 2 connector (A), and remove the breather pipe (B), then remove the intake air duct (C). 3. Remove the positive crankcase ventilation (PCV) hose (A), brake booster vacuum hose (B), vacuum hose (C) and vacuum line mounting bolts (D). 4. Remove the evaporative emission (EVAP) canister hose (A) and the transmission breather hose clamp bracket (B). 5. Remove and plug the water bypass hoses (C). 6. Remove the engine wire harness connectors and wire harness clamps from the intake manifold. Intake air temperature (IAT) sensor 1 connector Throttle actuator connector Manifold absolute pressure (MAP) sensor connector Evaporative emission (EVAP) canister purge valve connector ? Intake manifold tuning (IMT) (intake manifold runner control (IMRC)) actuator connector 7. Remove the upper cover mounting bolts and nuts sequentially in two or three steps, then remove the upper cover. Remove the intake manifold mounting bolts and nuts sequentially in two or three steps, then remove the intake manifold and spacer.