Download 2018 Honda Civic Remote Engine Start System Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, clean the transmitter where the ID label will attach. • Attach the ID label to the transmitter as shown. 3. Release the passenger’s sunvisor from the passenger’s sunvisor holder. 4. Remove the passenger’s sunvisor holder by rotating it 90° counterclockwise. 5. Remove the driver’s sunvisor and unplug the vehicle connector:
• Pivot the driver’s sunvisor downward. • Wrap tape around the tip of flat-tip screwdriver. • Locate the slot in the base cover, and insert the flat-tip screwdriver into the slot. Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate it toward the door. NOTE: If the retaining tab does not stay pushed in, return the sunvisor to its original position and repeat this step. 6. Remove the driver’s sunvisor holder by rotating it 90° counterclockwise.