Download 2018 Honda Civic Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Remove three self-tapping screws from the left front inner fender. 3. Secure the left front splash guard with three self-tapping screws in the order shown below. NOTE: Make sure there is no gap between the left front splash guard and the vehicle body. If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and retighten the self-tapping screws.
Installing the Rear Splash Guards 4. Remove one self-tapping screw and one clip from the rear bumper. 5. Locate the recessed mark. Using a pushpin, pierce the rear bumper at the recessed mark. 6. Install one spring nut on the rear bumper. Make sure to install the spring nut in the correct position and orientation. 7. Secure the left rear splash guard with two self-tapping screws in the order shown below. NOTE: Make sure there is no gap between the left rear splash guard and the bumper.