Home Auto Repair How to Install the Ambient Lights on a 2018 Honda CR-V

How to Install the Ambient Lights on a 2018 Honda CR-V

85

Download 2018 Honda CR-V Ambient Lights Installation Instructions – 1. Disconnect the negative cable from the battery.
2. Pull away the door opening seal and remove the passenger’s dashboard side lid. 3. Remove the passenger’s dashboard under cover. 4. Open the glove box and remove the three self-tapping screws. 5. Close the glove box and remove it. 6. Remove the driver’s dashboard under cover. 7. Remove the driver’s dashboard lower cover and unplug the vehicle connectors. 8. Apply masking tape as shown.

9. Remove the center outlet and unplug the vehicle connector. 10. Remove the climate control unit and unplug the vehicle connector. 11. Remove the audio unit and unplug the vehicle connectors. 12. Using isopropyl alcohol on a shop towel, thoroughly clean the fuse case where the fuse label will attach. Attach the fuse label (2A AMBIENT LIGHT) to the fuse case on the ambient light harness. 13. Line up the edge of green tape on the ambient light harness with the clip on the vehicle harness and secure the ambient light harness to the vehicle harness with one wire tie as shown.