Download 2018 Honda HR-V Cargo Liners Installation Instructions – Installing the Cargo Liners 1. Remove the tonneau cover, if equipped. 2. Pull the levers and fold each rear seat-back forward. • If the vehicle is equipped with ACC socket, continue with step 3. otherwise, go to step 4. With ACC socket 3. Align template A with the right rear side trim panel as shown. Attach it to the right rear side trim panel using masking tape. Go to step 5. Without ACC socket 4. Align template A with the right rear side trim panel as shown. Attach it to the right rear side trim panel using masking tape.
5. Using a pushpin, pierce the right rear side trim panel through the hole in template A. 6. Remove template A. 7. While wearing eye protection, drill one pierced mark to 10 mm: • Wrap tape around each drill bit 5 mm (0.2 in.) from the tip or use a drill stop. • First drill with a 3 mm drill bit, then with a 6 mm drill bit, and finish with an 8 mm drill bit. • Remove any burrs. 8. Press one well nut into the hole in the right rear side trim panel. 9. Place a washer on the snap-screw and install one snap-screw into the well nut. Securely tighten the snap-screw.