Download 2018 Honda HR-V Remote Engine Start Instructions Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, clean the transmitter where the ID label will attach. • Attach the ID label to the transmitter in the area shown. 3. Remove the driver’s sunvisor and unplug the vehicle connector: • Pivot the driver’s sunvisor downward. • Wrap tape around the tip of flat-tip screwdriver. • Locate the slot in the base cover, and insert the flat-tip screwdriver into the slot.
Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate it toward the door. NOTE: If the retaining tab does not stay pushed in, return the sunvisor to its original position and repeat this step. 4. Remove the driver’s sunvisor holder: • Wrap tape around the tip of flat-tip screwdriver. • Release three retaining tabs on the driver’s sunvisor holder. • While pulling down on the driver’s sunvisor holder as shown, use a flat-tip screwdriver wrapped with a tape to remove the driver’s sunvisor holder.