Home Auto Repair How to Install Body Side Moldings on 2018 Honda Fit

How to Install Body Side Moldings on 2018 Honda Fit

123

Download 2018 Honda Fit Body Side Moldings Installation Instructions – 1. Fold the front template tab in the direction shown. 2. Align the front template tab with the left front door as shown. 3. Align the bottom of the front template with the edge of the left front door, and attach it with masking tape. 4. Fold the rear template tab in the direction shown. 5. Align the rear template tab with the left rear door as shown. 6. Align the bottom of the rear template with the edge of the left rear door, and attach it with masking tape.

7. Using two alcohol swabs, clean the doors surface above the templates where the body side moldings will attach. Allow the alcohol to dry before installing the body side moldings. Installing the Front Body Side Moldings 8. Peel back about 40 to 50 mm (1.5 to 2.0 in.) of adhesive backing from each adhesive strip, and tape the ends to the front surface of the molding. Remove the other adhesive backings. If the vehicle is equipped with the accessory door edge guards or door edge films, go to step 10; otherwise, continue with step 9.