Download 2018 Honda Fit Door Visors Installation Instructions – Installing the Front Door Visor 1. Open the left front door glass. 2. Peel back the glass run channel in the areas shown. 3. Install the two brackets A between the door sash and the glass run channel at the measurements shown. Seat the glass run channel properly around the brackets. 4. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the left front door visor will attach. 5. Peel back the adhesive backings from each adhesive tape, and tape the ends to the front surface
of the left front door visor with masking tape.
6. Align the clip holes in the left front door visor with the bracket holes, and install the clip while pushing up on each bracket A. There should be no clearance between the brackets and the door sash. NOTE: Be extremely careful when installing the clips, they cannot be reinstalled after installation. 7. Adjust the left front door visor to the position as shown. 8. While applying light pressure against the left front door visor, carefully remove the adhesive backings in the order shown. Use your finger to push up each bracket so there is no gap between the bracket and the door sash.