Home Auto Repair How to Install Remote Engine Start System on 2018 Honda Fit

How to Install Remote Engine Start System on 2018 Honda Fit

192

Download 2018 Honda Fit Remote Engine Start System Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Attach the ID label. • Using isopropyl alcohol on a shop towel, clean the transmitter where the ID label will attach. • Attach the ID label to the transmitter. 3. Remove the roof console: • Using a plastic trim tool, remove the left and right lenses.• Remove the roof console, and unplug the vehicle connectors. 4. Release the passenger’s sunvisor from the right sunvisor holder. 5. Remove the right sunvisor holder: • Wrap masking tape around the tip of a flat-tip screwdriver.

• Release the three retaining tabs on the right sunvisor holder. • While holding down the right sunvisor holder as shown, use a flat-tip screwdriver wrapped with masking tape to remove the right sunvisor holder. 6. Remove the driver’s sunvisor: • Pivot the driver’s sunvisor downward. • Wrap masking tape around the tip of a flat-tip screwdriver. • Locate the slot in the base cover, and insert the flat-tip screwdriver into the slot. Push in and hold the retaining tab. • While holding the retaining tab, push up on the sunvisor and rotate it toward the door.