Download 2018 Honda Fit Shift Lever Knob Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Open the glove box, push inward on the stops, and remove the glove box. 3. Apply masking tape as shown. 4. Remove the center lower cover, and unplug the vehicle connectors. 5. Remove the shift lever knob. 6. Remove the parking brake cover trim. 7. Remove the center console rear trim. 8. Remove the center console, and unplug the vehicle connectors. 9. Remove the shift lever boot. 10. Secure the shift lever boot to the center console with the supplied screws. 11. Install the center console.
Then, install the ring on the shift lever as shown. 12. Install the shift lever knob on the shift lever, and tighten the ring as shown. 13. Secure the shift lever boot on the ring. 14. Check that all wire harnesses are routed properly and all connectors are plugged in. 15. Install all removed parts. 16. Connect the negative cable to the battery. 17. Press and hold the audio unit power button for 2 seconds to restore the audio and navi (if equipped) system functions. 18. Set the clock. 19. If necessary, restore the systems back to normal operation as described in the service information. Check the Shift Lever Knob Operation