Home Auto Repair How to Install the Tie-Downs on a 2018 Honda Fit

How to Install the Tie-Downs on a 2018 Honda Fit

211

Download 2018 Honda Fit Tie-Downs Installation Instructions – 1. Pull both levers and fold each rear seat-back forward. 2. Lift the cargo board and remove the tape attached to the vehicle panel. 3. Put the cargo area left side trim panel down. Mark the cargo area left side trim panel at the measurements shown. 4. Use a utility knife to cut out the cargo area left side trim panel as shown.

5. Install one tie-down using the bolt supplied. Torque the bolt to 9.8 N·m (7.2 lb·ft). 6. Repeat steps 2 through 5 to install a tie-down on the right side of the vehicle. Return the cargo board to the original position. NOTE: Be careful not to damage the body. PARTS LIST: 2 Tie-downs TOOLS AND SUPPLIES REQUIRED Utility knife, Ratchet, 10 mm Socket, Ruler, Felt-tip pen, Torque wrench