Home Auto Repair How to Install the Backup Sensors on a 2018 Honda Odyssey

How to Install the Backup Sensors on a 2018 Honda Odyssey

205

Download 2018 Honda Odyssey Backup Sensors Installation Instructions – 1. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the intake air tube. • Disconnect the negative cable from the battery. 2. Remove the right rear door sill trim. 3. Remove the rear trim panel. 4. Stow the third row seats. 5. Apply masking tape to the right C-pillar trim and right D-pillar trim as shown. 6. Using the plastic trim tool, open the two covers and remove the two self-tapping screws.

7. Remove the side hook from the right rear side trim panel. 8. Pull away the door opening seal and weatherstrip from around the right rear side trim panel. Remove the right rear side trim panel, and unplug the vehicle connectors (if equipped). 9. Release the roof end trim panel. NOTE: Do not damage the roof end trim panel. 10. Pull the coat hook, and remove the self-tapping screw. 11. Using the plastic trim tool, open the cover and remove the bolt. 12.Pull away the weatherstrip from around the right D-pillar trim. Remove the right D-pillar trim.