Download 2018 Honda Odyssey Splash Guard Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Remove the two self-tapping screws from the left front inner fender. 3. Using a pushpin, pierce the center of the two clips on the left front inner fender. 4. Secure the left front splash guard with four self-tapping screws in the order shown below. NOTE: Make sure there is no gap between the left front splash guard and the vehicle body.
If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and retighten the screws. 5. Turn the steering wheel fully clockwise, and repeat steps 2 through 4 for the right side of the vehicle. Installing the Rear Splash Guards 6. Remove the three self-tapping screws and one clip from the rear bumper and left rear inner fender. 7. Locate the recessed mark. Using a pushpin, pierce the rear bumper at the recessed mark. NOTE: Make sure to pierce the recessed mark perpendicular to the rear bumper.