Download 2018 Honda Pilot 18-inch Aluminum Wheel Installation Instructions – 1. Remove the tire, valve nut, washer, and tire pressure sensor from the standard wheel to use for accessory wheel. 2. Remove and discard the grommet from the tire pressure sensor. NOTE: If the grommet is missing from the tire pressure sensor, make sure it is not stuck in the wheel. 3. Install the new grommet onto the tire pressure sensor. 4. Before installing the tire pressure sensor, clean the mating surface on the sensor and aluminum wheel.
5. Install the tire pressure sensor and the washer on the aluminum wheel, and hand tighten the valve nut. Make sure the pressure sensor is resting on the wheel. 6.While holding the tire pressure sensor against the wheel, tighten the valve nut to the specified torque. Tightening torque: 8 N·m (5.9 lb·ft) NOTE: • Check the grommet on the tire pressure sensor to make sure it is seated properly. • Make sure the valve stem does not protrude into the sensor housing surface. • To prevent the sensor housing from getting caught on the bead of the tire, ….