Download 2018 Honda Pilot 20-inch Aluminum Wheel Installation Instructions – TPMS Installation 1. Before installing the tire pressure sensor, clean the mating surface on the sensor and the aluminum wheel. 2. Install the tire pressure sensor and the washer on the aluminum wheel, and tighten the valve nut finger tight. Make sure the tire pressure sensor is resting on the wheel. 3. While holding the tire pressure sensor against the wheel, tighten the valve nut to the specified torque. Tightening torque: 8 N·m (5.9 lb·ft) 4. Install the tires according to the instructions in the service manual.
5. Install the wheels on the vehicle and torque to 127 N·m (94 lb·ft). Models equipped with standard 20” wheels. 6.Initialize the tire pressure sensors by driving the vehicle for at least 40 seconds at15 mph. Continue to step 7 for models equipped with standard 18” wheels. 7.Using isopropyl alcohol on a shop towel, clean the existing accessory tire and loading information label. Remove the adhesive backing from the new accessory tire and loading information label, and attach it over the existing label.