Download 2018 Honda Pilot Door Visors Installation Instructions – Installing the Front Door Visor 1. Fully open the left front door glass. 2. Pull back the glass run channel. 3. Install two brackets A to the door sash as shown. 4. Install the glass run channel and secure the two brackets A. Check that the two brackets A are installed on the door sash as shown. Check that the glass run channel is installed properly. 5. Insert one bracket B into the door sash as shown. 6. Using an alcohol swab, thoroughly clean the area where the left front door visor will attach.
7. Attach a piece of masking tapes to the end of the adhesive backings as shown. Peel back the adhesive backings partway and temporarily attach them to the front surface of the left front door visor. 8. Adjust the two brackets A and one bracket B so the holes line up with the three holes on the left front door visor. 9. Secure the left front door visor to two brackets A and one bracket B with three clips. Make sure to push up on the two brackets A and one bracket B while installing the clips. NOTE: The clips cannot be removed and reinstalled after installation.