Download 2018 Honda Pilot Full Nose Mask Installation Instructions – Removing the Vehicle Parts 1. Wrap a shop towel around the hood latch. 2. Remove the front bulkhead cover. 3. Remove the intake air guide. Installing the Hood Section 4. Fit the corners of the mask (hood section) around the hood. Adjust the mask so that it fits smoothly over the edges. Attach three hooks to the hood. Do not fold back the rubber seal inside the hood when installing the hook. Remove / install the hooks by inserting your finger into the belt of each hook.
Pulling the hooks with excessive force can break the hook strap. Installing the Bumper Section 5. Remove the three self-tapping screws from the left front fender and front bumper. 6. Place three washers onto the three snap-screws, then install and securely tighten the three snap-screws. 7. Repeat steps 5 and 6 on the right side of the vehicle. 8. Pull the mask back toward the fenderwell, smooth out any wrinkles, and then secure the three snaps on the mask onto the three snap-screws.