Home Auto Repair How to Install Running Board Lights on 2018 Honda Pilot

How to Install Running Board Lights on 2018 Honda Pilot

125

Download 2018 Honda Pilot Running Board Lights Installation Instructions – 1. Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the intake air tube. • Disconnect the negative cable from the battery, then wait at least 3 minutes before starting work. 2. Remove the passenger’s dashboard under cover and unplug the vehicle connector. 3. Remove the passenger’s door sill trim. 4. Pull away the door opening seal, and remove the passenger’s kick panel. 5. Pull away the door opening seal, and remove the driver’s dashboard side lid.

6. Remove the driver’s dashboard lower cover, unplug the vehicle connectors, and release the vehicle sensor. 7. Remove the driver’s door sill trim. 8. Pull away the door opening seal, and remove the driver’s kick panel. 9. Locate the two presets in the left side sill panel. Using an utility knife, cut out the left side sill panel along each preset. Remove any burrs. 10. Remove the undercoating in the areas shown. Apply touch-up paint to the areas where you removed the undercoating, and allow them to dry thoroughly.