Home Auto Repair How to Install the Running Boards on a 2018 Honda Pilot

How to Install the Running Boards on a 2018 Honda Pilot

125

Download 2018 Honda Pilot Running Boards Installation Instructions – 1. Locate the two presets in the left side sill panel. Using an utility knife, cut out the left side sill panel along the each preset. Remove any burrs. 2. Remove the undercoating in the areas shown. Apply touch-up paint to the areas where you removed the undercoating, and allow them to dry thoroughly. 3. Loosely secure the left bracket A and left bracket C to the vehicle panel with four flange bolts.

4. Secure the left running board to the left bracket A and left bracket C with four flange bolts. Torque the flange bolts to 27 N·m (20 lb·ft). NOTE: Have an assistant help you when installing the running board. 5. Tighten the four flange bolts loosely installed in step 3. Torque the flange bolts to 27 N·m (20 lb·ft). 6. Repeat steps 1 through 5 on the right side of the vehicle to install the right running board.