Download 2018 Honda Pilot Surfboard Attachment Installation Instructions – 1. Loosely install a bolt, knob, and metal bracket to a base. 2. Position the base on the crossbar. Loosely install a bolt and knob as shown. 3. Repeat steps 1 and 2 for the three remaining bases. 4. Center the surfboad upside down on the roof of the vehicle with the tail toward the front of the vehicle. NOTE: When mounting two boards, place the second board on top of the first. 5. Adjust the position of the bases so that the bottom of the surfboard rests on the rubber part of the bases. Tighten all knobs firmly and evenly.
NOTE: The crossbars must be at least 24 in. (610 mm) apart for safe use. 6. Slide the buckle on an attachment strap into the clip on the base. NOTE: For proper alignment, the buckle must be fully inserted into the clip as shown. 7. Rotate the buckle up to lock it to the base. Attach the buckle at the other end of the strap to the other base and lock it in place. 8. Repeat steps 6 and 7 to install the other strap. 9. Pull the ends of the attachment straps to secure the surfboard to the carrier.