Download 2018 Honda Ridgeline Door Visors Installation Instructions – Installing the Front Door Visor 1. Fully lower the left front door glass. 2. Pull out the glass run channel as shown. 3. Install two brackets A between the door sash and the glass run channel as shown. Then, seat the glass run channel properly around the brackets. 4. Install one bracket B to the door sash as shown. 5. Use one alcohol swab to thoroughly clean the area where the left front door visor will attach.
6. Attach a piece of masking tape to the end of the adhesive backings as shown. Peel back the adhesive backings partway and temporarily attach them to the front surface of the left front door visor. 7. Line up the two brackets A and one bracket B so the holes line up with the three holes on the left front door visor. 8. Secure the left front door visor to two brackets A and one bracket B with three clips. Make sure to push up on the two brackets A and one bracket B while installing the three clips. NOTE: Be extremely careful when installing the clips; they cannot be reinstalled if removed.