Home Auto Repair How to Install Front Splash Guards on 2018 Honda Ridgeline

How to Install Front Splash Guards on 2018 Honda Ridgeline

86

Download 2018 Honda Ridgeline Front Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Using a pushpin, pierce the center of the top two clips on the left front inner fender. NOTE: Make sure to pierce perpendicular to the left front inner fender. 3. Remove this self-tapping screw from the left front inner fender. 4. Loosely install the left front splash guard onto the left front inner fender with two 5 x 20 mm self-tapping screws and the self-tapping screw removed in step 3.

5. While holding the left front splash guard against the left front inner fender, tighten the self-tapping screws in the order shown. NOTE: Make sure there is no gap between the left front splash guard and the vehicle body. If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and retighten the screws. 6 .Turn the steering wheel fully clockwise, and repeat steps 2 through 5 to install the right front splash guard.