Download 2018 Honda Ridgeline Full Nose Mask Installation Instructions – Installing the Hood Section 1. Open the hood. Fit the corners of the hood section around the hood and adjust it so it fits smoothly over the edges. Attach the three hooks to the hood. NOTE: Do not fold back the rubber seal inside the hood when installing the hook. Pulling the hooks with excessive force can break the hook strap. Installing the Bumper Section 2. Remove the three self-tapping screws from the left front fender and front bumper.
3. Install the three snap-screws and three washers on the front bumper. 4. Repeat steps 2 and 3 on the right side of the vehicle. 5. Pull the mask back toward the fenderwell, smooth out any wrinkles then secure the three snaps on the mask to the three snap-screws. 6. Attach one hook to the fenderwell. 7. Repeat steps 5 and 6 on the right side of the vehicle. 8. Insert the five tabs under the left headlight. 9. Insert one tab into the left turn signal light. 10. Repeat steps 8 and 9 on the right side of the vehicle.