Home Auto Repair How to Install Illuminated Door Sill Trims on 2018 Honda Ridgeline

How to Install Illuminated Door Sill Trims on 2018 Honda Ridgeline

108

Download 2018 Honda Ridgeline Illuminated Door Sill Trims Installation Instructions – 1. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the intake air tube. • Disconnect the negative cable from the battery. 2. Remove the passenger’s dashboard under cover and unplug the vehicle connector (if equipped). 3. Remove the passenger’s door sill trim. 4. Pull away the door opening seal and remove the passenger’s kick panel.

5. Pull away the door opening seal and remove the driver’s dashboard side lid. 6. Remove the driver’s dashboard lower cover, unplug the vehicle connectors, and release the vehicle sensor. 7. Remove the driver’s door sill trim. 8. Pull away the door opening seal and remove the driver’s kick panel. 9. Using scissors, cut the protective tape as shown. 10. Pull away the door opening seal, as shown. 11. Using an alcohol swab, thoroughly clean the vehicle panel where the illuminated door sill trim will attach. 12. Remove the two adhesive backings from the illuminated door sill trim.