Home Auto Repair How to Install the Running Boards on a 2018 Honda Ridgeline

How to Install the Running Boards on a 2018 Honda Ridgeline

112

Download 2018 Honda Ridgeline Running Boards Installation Instructions – 1. Using a utility knife, cut out the left side sill panel as shown. Remove any burrs. 2. Remove the undercoating as shown. Apply touch-up paint where you removed the undercoating and allow it to dry thoroughly. 3. Loosely install the left bracket A, left bracket B, and left bracket C to the vehicle panel with six flange bolts. NOTE: Make sure that the brackets are installed in the correct positions and orientations.

4. With the help of an assistant, install the left running board to the left bracket A, left bracket B, and left bracket C with six flange bolts. Torque the flange bolts to 27 N·m (20 lb·ft). 5. Tighten the six flange bolts loosely installed in step 3. Torque the flange bolts to 27 N·m (20 lb·ft). 6. Repeat steps 1 through 5 on the right side of the vehicle. NOTE: • Thoroughly clean the bottom of the body between the front and rear wheels. • Do not damage the body paint finish.