Home Auto Repair How to Install 19-inch Aluminum Wheel on 2019 Acura RLX

How to Install 19-inch Aluminum Wheel on 2019 Acura RLX

140

Download 2019 Acura RLX 19-inch Aluminum Wheel Installation Instructions – 1. Before installing the tire pressure sensor, clean the mating surface on the sensor and the aluminum wheel. 2. Install the tire pressure sensor and the washer in the aluminum wheel. Install the valve nut and tighten it finger tight. Make sure the tire pressure sensor is resting on the wheel. 3. While holding the tire pressure sensor against the wheel, tighten the valve nut to the specified torque. Tightening torque: 8.0 N·m (5.9 lb-ft)

NOTE: • Check the grommet on the tire pressure sensor to make sure it is seated properly. • Make sure the valve stem does not protrude into the sensor housing surface. • To prevent the sensor housing from getting caught on the bead of the tire, install the tire pressure sensor so that the sensor housing does not protrude into the bead area of the wheel. • Do not reuse a grommet that had been tightened, even one time, to the specified torque, as it is deformed inside. • Do not use pneumatic or electric tools on the valve nut. • Tightening the nut above the specified torque can damage the grommet.