Home Auto Repair How to Install the Pattern Projectors on a 2019 Acura RLX

How to Install the Pattern Projectors on a 2019 Acura RLX

176

Download 2019 Acura RLX Pattern Projectors Installation Instructions – 1. Disconnect the negative cable from the battery.
NOTE: For Hybrid vehicle, make sure not to disconnect the negative cable from the battery three minutes after turning the engine switch to OFF. 2. Remove the pull pocket cap and the self-tapping screw. 3. Remove the left front door panel and unplug the vehicle connectors. 4. Remove the courtesy light and unplug the vehicle connector. 5. Repeat steps 2 through 4 on the right side of the vehicle. 6. Secure the left light harness 2-pin connector and left light harness to the left light with one wire tie.

NOTE: Make sure to check the shape (identification mark) before installation. 7. Install the left light to the left front door panel with two self-tapping screws, two collars, and two brackets. 8. Plug the harness 2-pin connector into the left light harness 2-pin connector and plug the vehicle 2-pin connector into the remaining harness 2-pin connector. Secure the 2-pin connectors and harness to the vehicle harness with one wire tie. 9. Secure the right light harness 2-pin connector and right light harness to the right light with one wire tie. NOTE: Make sure to check the shape (identification mark) before installation.