Download 2019 Acura RLX Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Using a pushpin, pierce the center clip shown on the left front inner fender. 3. Remove three self-tapping screws from the left front inner fender. 4. Install the left front splash guard to the left front inner fender with one self-tapping screw supplied, and the three self-tapping screws removed in step 3 in this order . Make sure there is no gap between the left front splash guard and the vehicle body.
If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and tighten the self-tapping screws. 5. Turn the steering wheel fully clockwise and repeat steps 2 through 4 to install the right front splash guard. Installing the Rear Splash Guards 6. With the vehicle on a lift. Line up the template with the rear bumper as shown and attach it with masking tape. 7. Using a pushpin, pierce the center of the mark on the template. 8. Remove the template.