Home Auto Repair How to Install the Backup Sensors on a 2019 Acura TLX

How to Install the Backup Sensors on a 2019 Acura TLX

121

Download 2019 Acura TLX Backup Sensors Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Pull the two levers, and fold both rear seat backs forward. 3. Pull away the weatherstrip, and remove the six clips from the trunk upper trim panel. 4. Remove the trunk floor lid. 5. Remove the trunk rear trim panel. 6. Remove the tool box. 7. Remove the trunk floor lining. 8. Pull away the weather strip. Remove the left trunk side trim panel. 9. Remove the rear bumper. • Apply masking tape to the rear bumper, tail lights, and rear fenders as shown.

• Remove the two caps, two flange bolts, six self-tapping screws and two clips. • Release the nine retaining tabs on each side of the bumper. • Release the two retaining tabs on each side of the bumper. •With the help of an assistant, remove the rear bumper. • Place the rear bumper on a blanket. 10. Mark the inside of the rear bumper: • Locate the four scribe marks on the inside of the rear bumper at the center and left side. • Using a pushpin, pierce the rear bumper at the top and center of the two marks. NOTE: There are several markings on the inside of the rear bumper.