Home Auto Repair How to Install the Cargo Hook on a 2019 Acura TLX

How to Install the Cargo Hook on a 2019 Acura TLX

216

Download 2019 Acura TLX Cargo Hook Installation Instructions – 1. Open the trunk. Pull away the weatherstrip, and remove the six clips from the trunk upper trim panel. 2. Pull down the trunk upper trim panel. Push the tab, then pull down the right seat-back release lever to release the hook and remove the lever. Remove the left seat-back release lever the same way. 3. Thread the rivet nut onto the mandrel of the 6 mm rivet nut tool as shown. 4. Insert the rivet nut into the hole in the vehicle panel, and install the hex wrench on the rivet nut tool.

5. While holding the rivet nut tool with the hex wrench, use a the 19 mm open end wrench to rotate the tool counterclockwise. 6. Remove the rivet nut tool from the rivet nut by turning the hex wrench counterclockwise. 7. Using a felt-tip pen, mark the trunk upper trim panel as shown. 8. Using a pushpin, pierce the trunk upper trim panel at the mark made in step 7. 9. While wearing eye protection, drill the pierced mark in the trunk upper trim panel to 32 mm. First drill with a 3 mm drill bit, and finish with a 32 mm hole saw. Remove any burrs. 10.Reinstall the seat-back release levers and the trunk upper trim panel.