Home Auto Repair How to Install 20-inch Aluminum Wheel on 2019 Acura RDX

How to Install 20-inch Aluminum Wheel on 2019 Acura RDX

115

Download 2019 Acura RDX 20-inch Aluminum Wheel Installation Instructions – 1. Before installing the tire pressure sensor, clean the mating surface on the sensor and the aluminum wheel. 2. Install the tire pressure sensor and the washer on the aluminum wheel, and tighten the valve nut, finger tight. Make sure the pressure sensor is resting on the wheel. 3. While holding the tire pressure sensor against the wheel, tighten the valve nut to the specified torque. Tightening torque: 5.9 lb-ft (8.0 N·m) 4. Install the tires according to the instructions in the service information.

5. Install the wheels on the vehicle, and torque to 80 lb-ft (108 N·m). 6. Drive the vehicle for at least 40 seconds at a speed of 15 mph (24 km/h) or more. All sensor IDs will be memorized automatically. Do steps 7-18 for models not equipped with standard 20″ wheels. 7. Open the driver’s door. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the tire pressure information label will attach. Remove the adhesive backing from the tire pressure information label, and attach it over the standard tire pressure information label as shown.