Home Auto Repair How to Install Cargo Area Protectors on 2019 Acura RDX

How to Install Cargo Area Protectors on 2019 Acura RDX

111

Download 2019 Acura RDX Cargo Area Protectors Installation Instructions – Installing the Cargo Area Protectors 1. Fold down the left and right rear seat-backs. 2. Center the snaps on the left and right rear seat-back protectors, and tape them in place on the back surface as shown. NOTE: Follow the same procedure for three remaining cargo protectors. 3. Place the left rear seat-back protector on the left rear seat-back. Line it up with two tether anchors as shown. 4. Lift the edge of the left rear seat-back protector.

Apply masking tape to the left rear seat-back where the snap No. 1 will be located. 5. Using a T-pin, pierce the left rear seat-back through the hole in snap No. 1 as shown. NOTE: Make sure you pierce perpendicular to the left rear seat-back. 6. Remove the left rear seat-back protector. 7. While wearing eye protection, drill the pierced mark in step 5 to 3 mm. Drill with a 3 mm drill bit. NOTE: • Wrap masking tape around a 3 mm drill bit, 10 mm (0.39 in.) away from the tip, or use a drill stop. • Make sure to drill perpendicular to the left rear seat-back.