Home Auto Repair How to Install the Parking Sensors on a 2019 Acura RDX

How to Install the Parking Sensors on a 2019 Acura RDX

155

Download 2019 Acura RDX Parking Sensors Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Pull away the door opening seal, and remove the driver’s dashboard side lid. 3. Remove the driver’s dashboard side vent. 4. Remove the left trim, and unplug the vehicle connector. 5. Remove the driver’s dashboard lower cover, and unplug the vehicle connectors and vehicle sensor. 6. Release and pull up on the rear seat cushion. NOTE: Place a piece of masking tape as shown to prevent the hook from engaging.

7. Remove the left rear door sill trim. 8. Remove the cargo floor board. 9. Remove the four tie-down hooks. 10. Remove the left and right cargo strips. 11. Remove the cargo bin. 12. Remove the rear panel lining. 13. Remove the two bolts. Loosen the bolt, and turn the left bracket as shown. 14. Fold down the left rear seat-back. 15. Gently pull the inner handle on the left rear side trim panel, and use a small flat-tip screwdriver wrapped with a shop towel to remove the inner handle cap. 16. Remove the two screws from the left rear side trim panel.