Home Auto Repair How to Install the Splash Guards on a 2019 Acura RDX

How to Install the Splash Guards on a 2019 Acura RDX

552

Download 2019 Acura RDX Splash Guards Installation Instructions – Installing the Front Splash Guards 1. Turn the steering wheel fully counterclockwise. 2. Using a pushpin, pierce the center of the two clips on the left front inner fender. NOTE: Make sure to pierce the clips perpendicular. 3. Remove the two self-tapping screws from the left front inner fender. 4. Loosely install the left front splash guard to the left front inner fender with the four self-tapping screws supplied. 5. While holding the left front splash guard against the left front inner fender, tighten the four self-tapping screws as shown.

NOTE: Make sure there are no gaps between the left front splash guard and the vehicle body. If there is a gap, loosen the self-tapping screws, hold the splash guard against the body, and tighten the screws. 6. Turn the steering wheel fully clockwise, and repeat steps 2 through 5 on the right side of the vehicle. Installing the Rear Splash Guards 7. Remove the two self-tapping screws from the left rear inner fender. 8. Using a pushpin, pierce the center of the two dimples in the left rear inner fender. NOTE: Make sure to pierce the left rear inner fender perpendicular.