Home Auto Repair How to Install the Welcome Lights on a 2019 Acura RDX

How to Install the Welcome Lights on a 2019 Acura RDX

107

Download 2019 Acura RDX Welcome Lights Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Remove the passenger’s dashboard under cover, and unplug the vehicle connector. 3. Remove the passenger’s door sill trim. 4. Pull away the door opening seal, and remove the passenger’s kick panel. 5. Pull away the door opening seal, and remove the driver’s dashboard side lid. 6. Remove the driver’s dashboard side vent. 7. Remove the left trim, and unplug the vehicle connector. 8. Remove the driver’s dashboard lower cover, and unplug the vehicle connectors and vehicle sensor.

9. Remove the driver’s door sill trim. 10. Pull away the door opening seal, and remove the driver’s kick panel. 11. With the vehicle on a lift, remove the left floor under cover. 12. Remove the right floor under cover. 13. Using isopropyl alcohol on a shop towel, thoroughly clean the two fuse cases where the fuse labels will attach. Attach the fuse labels (2A PUDDLE LIGHT) to the fuse cases on the welcome light harnesses A. 14. Peel back the floor carpet, and remove the vehicle grommet from the vehicle panel.