Home Auto Repair How to Install Bicycle Attachment on 2019 Acura MDX

How to Install Bicycle Attachment on 2019 Acura MDX

119

Download 2019 Acura MDX Bicycle Attachment (Fork Mount) Installation Instructions – Installing the Bicycle Attachment 1. Assemble the rear clamp as shown. 2. Remove the end cap, and slide the rear clamp assembly into the bicycle attachment as shown. Then, install the end cap. 3. Use the change key to insert the lock cylinder into the fork skewer as shown. 4. Lift the front lever, and thread the front knob into the lever. 5. Loosen the thumbwheel on the slot side of the rear lower clamp, and let the rear lower clamp hang loose. 6. Place the bicycle attachment on the crossbars. Swing the rear lower clamp under the rear crossbar, and secure it as shown.

Use the torque tool to finish tightening the thumbwheel. 7. Loop the front clamp around and underneath the front crossbar. 8. Place the front clamp pin into the slot as shown. 9. While holding the front lever up, swing the front knob into the slot of the front clamp and tighten the front knob. 10. Push the front lever all the way down. If it is too firm and you cannot push the front lever all the way down, loosen the front knob and try again. If it is still too difficult to push down, change the front lever pin location and adjust the front knob until you can push the front lever all the way down.