Download 2019 Acura MDX Cargo Liner Installation Instructions – 1. Fold down the second row seats and third row seats. 2. Using a plastic trim tool, remove the cover from the left and right rear side trim panels by releasing the retaining tabs. 3. Line up the template with the left rear side trim panel as shown. Tape the template to the left rear side trim panel with strips of masking tape. 4. Using a pushpin, pierce the left rear side trim panel through the template at the three locations shown on the template. 5. Remove the template.
6. While wearing eye protection, drill the three pierced marks in the left rear side trim panel to 8 mm: • Wrap tape around a 3 mm, 6 mm, and an 8 mm drill bits, 15 mm (0.6 in.) away from the tip, or use a drill stop. • First drill with a 3 mm drill bit, then with a 6 mm drill bit, and finish with an 8 mm drill bit. • Remove any burrs. 7. Press one well nut into the each hole in the left rear side trim panel. 8. Place a washer onto the snap-screw and install three snap-screws into each well nut. Securely tighten the snap-screws. 9. At the rear of the left rear side trim panel, use your finger to locate the pre-drilled hole in the panel under the carpet.