Home Auto Repair How to Install Engine Block Heater on 2019 Acura MDX

How to Install Engine Block Heater on 2019 Acura MDX

198

Download 2019 Acura MDX Engine Block Heater Installation Instructions – 1. Allow the engine and all cooling system components to cool down. 2. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. 1. Allow the engine and all cooling system components to cool down. 2. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the air intake tube. • Disconnect the negative cable from the battery. 3. Remove the front bumper. • Apply masking tape as shown. • Remove the air intake guide.

• Remove the four self-tapping screws, the six push rivet clips, the four clips, the four washerbolts, and the four flange bolts. • Release the three retaining tabs on each side. • With the help of an assistant, release the four retaining tabs on each side. • With the help of an assistant, release the front bumper and unplug the vehicle connectors. • If the vehicle is equipped with headlight washers, place a clean container under the tube end to collect the washer fluid. Disconnect the headlight washer tube. • Remove the front bumper. Place the front bumper on a blanket to prevent damage.