Home Auto Repair How to Install Front and Rear Parking Sensor on 2019 Acura MDX

How to Install Front and Rear Parking Sensor on 2019 Acura MDX

164

Download 2019 Acura MDX Front and Rear Parking Sensor Installation Instructions – Removing the Vehicle Parts 1. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the air intake tube. • Disconnect the negative cable from the battery. 2. Remove the front bumper: • Apply masking tape as shown on each side. • Remove the air intake guide. • Remove the four self-tapping screws, the two push rivet clips, the four clips, the four short clips, the four washer-bolts, and the four flange bolts. • Release the three retaining tabs on each side.

• With the help of an assistant, release the four retaining tabs on each side. • With the help of an assistant, release the front bumper. Place the front bumper on the blanket to prevent damage. 3. Open the glove box by pushing the button (unlock with the built-in key). Remove the passenger’s dashboard side vent. 4. Remove the passenger’s dashboard trim panel. Close the glove box. 5. Remove the dashboard center panel and unplug the vehicle connector. 6. Remove the passenger’s dashboard center lower cover. 7. Pull away the door opening seal and remove the driver’s dashboard side lid.