Download 2019 Acura MDX Heated Steering Wheel Installation Instructions – 1. Turn the steering wheel so the front wheels are in the straight-ahead position. 2. Lower the steering wheel by moving the adjustment switch. 3. Apply masking tape to the upper cover as shown. 4. Turn the ignition to OFF. NOTE: The steering wheel automatically moves fully in and up. Make sure the steering wheel is not interfering with the vehicle parts. 5. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the air intake tube.
• Disconnect the negative cable from the battery and wait at least 3 minutes before you start to install the steering wheel. 6. Pull away the door opening seal and remove the driver’s dashboard side lid. 7. Remove the driver’s dashboard side vent. 8. Remove the driver’s outer dashboard trim. 9. Remove the driver’s dashboard lower cover. 10. Remove the two TORX bolts. 11. Unplug the two vehicle 2-pin connectors and the vehicle 1-pin connector by pulling up on the locking tabs. NOTE: Be careful not to damage the connectors. 12. Remove the airbag. Do not drop the removed airbag or hit it on an object.