Home Auto Repair How to Install Pattern Projectors on 2019 Acura MDX

How to Install Pattern Projectors on 2019 Acura MDX

138

Download 2019 Acura MDX Pattern Projectors Installation Instructions – 1. Disconnect the negative cable from the battery: • Wrap a shop towel around the hood latch. • Remove the front bulkhead cover. • Remove the air intake tube. • Fully open the left and right front door glasses. • Disconnect the negative cable from the battery. NOTE: For Hybrid vehicle, make sure not to disconnect the negative cable from the battery 3 minutes after turning the engine switch to OFF. 2. Remove the inner handle cap and the three self tapping screws. 3. Remove the right front door panel, and unplug the vehicle connectors.

4. Remove the inner handle cap and the three self tapping screws. 5. Remove the left front door panel, and unplug the vehicle connectors. Installing the Lights 6. Attach the template to the left front door panel with masking tape as shown. 7. Using a pushpin, pierce the center of three marks on the template. Remove the template. 8. While wearing eye protection, drill the three pierced marks on the left front door panel with a 3 mm drill bit. NOTE: Wrap masking tape around the drill bit 10 mm (0.39 in.) away from the tip, or use a drill stop.