Download 2019 Honda Accord 1.5L 19-inch Aluminum Wheel Kit Installation Instructions – 1. Install the trim to the aluminum wheel with the three nuts as shown. Torque the three nuts to 4.4 lb-ft (6 N·m). 2. Repeat same procedure for the remaining trims. Perform steps 3 through 19 for models not equipped with standard 19″ wheels. 3.Open the driver’s door. Using isopropyl alcohol on a shop towel, thoroughly clean the area where the tire pressure information label will attach. Remove the adhesive backing from the tire pressure information label, and attach the tire pressure information label over the standard tire pressure information label as shown.
NOTE: Confirm the spare tire size, and appropriate label. 4. Attach the Supplemental Information page included in this kit into the Owner’s Guide as described on the Important Information to Dealer page. Inch-up Tire Pressure Programming NOTE: Make sure you are using the latest i-HDS version as described on SIS. 5.Connect the i-HDS to the data link connector, then turn the ignition to ON. 6.Start the Diagnostic System, select Connect to the Vehicle. 7.Select System Selection Menu. 8.Select ABS/VSA, and click the check button. 9.Select TPMS (VSA) threshold, and click the check button.