Download 2019 Honda Accord 1.5L Cargo Hook Installation Instructions – Installing the Cargo Hook 1. Thread the rivet nut onto the mandrel of the 6 mm rivet nut tool as shown. 2. Insert the rivet nut into the hole in the vehicle panel, and install the hex wrench on the 6 mm rivet nut tool. NOTE: Make sure to insert the rivet nut in the correct position. 3. While holding the 6 mm rivet nut tool with the hex wrench, turn the 19 mm open end wrench counterclockwise to install the rivet nut into the vehicle panel.
4. Remove the 6 mm rivet nut tool from the rivet nut by turning the hex wrench counterclockwise. 5. Line up the cargo hook pin with the hole in the vehicle panel, and secure the cargo hook to the vehicle panel with one bolt, spring washer, and washer (small). Torque the bolt to 3.0 lb·ft (4.0 N·m). NOTE: • Be careful not to damage the body. • This instruction shows the cargo hook being installed on the left side of the vehicle. An additional cargo hook (sold separately) can be installed on the right side of the vehicle.