Home Auto Repair How to Install a Cargo Net on a 2019 Honda Accord 1.5L

How to Install a Cargo Net on a 2019 Honda Accord 1.5L

153

Download 2019 Honda Accord 1.5L Cargo Net Installation Instructions – Installing the Cargo Net 1. Open the trunk lid. Remove one clip from the left trunk side lining. Repeat on the right side of the vehicle. 2.While wearing eye protection, enlarge the clip hole in the left trunk side inner panel to 8 mm. NOTE: Wrap masking tape around the drill bit 15 mm (0.59 in.) from the tip, or use a drill stop. Make sure to drill perpendicular to the left trunk side inner panel. 3. Using a deburring tool, remove all burrs from the hole. 4. Apply touch-up paint to the hole, and allow the touch-up paint to dry.

5. Repeat steps 2 through 4 on the right side of the vehicle. 6. Install the ring into the hole enlarged in the step 2. Repeat on the right side of the vehicle. 7. Thread the rivet nut onto the mandrel of the 6 mm rivet nut tool as shown. 8. Insert the rivet nut into the hole in the vehicle panel, and install the hex wrench on the 6 mm rivet nut tool. NOTE: Make sure to insert the rivet nut in the correct position. 9. While holding the 6 mm rivet nut tool with the hex wrench, turn the 19 mm open end wrench counterclockwise to install the rivet nut into the vehicle panel.