Download 2019 Honda Accord 1.5L Door Visors Installation Instructions – Installing the Front Door Visor 1. Fully open the left front door glass. 2. Peel the glass run channel as shown. 3. Install the two brackets between the door sash and the glass run channel as shown. Seat the glass run channel properly around the brackets. NOTE: Confirm the two brackets are installed on the door sash as shown. Check that the glass run channel is seated properly. 4. Use an alcohol wipe to thoroughly clean the area where the left front door visor will attach.
5. Peel back the adhesive backings, and tape them to the front surface of the left front door visor with masking tape. 6. Adjust the two brackets so the holes line up with the two holes in the left front door visor. 7. Using the two clips, secure the left front door visor to the brackets as shown. Make sure to push up on the brackets while installing the two clips. NOTE: Be extremely careful when installing the clips; they cannot be reinstalled after installation. 8. Adjust the position of the left front door visor as shown.