Home Auto Repair How to Install Front Fender Trims on 2019 Honda Accord 1.5L

How to Install Front Fender Trims on 2019 Honda Accord 1.5L

120

Download 2019 Honda Accord 1.5L Front Fender Trims Installation Instructions – 1. Line up the template with the curve end, and attach it to the left front fender with masking tape as shown. 2. Using an alcohol wipe, thoroughly clean the left front fender where the left front fender trim will attach. 3. Peel back the adhesive backings, and tape them to the front surface of the left front fender trim with masking tape. Remove the remaining adhesive backings. 4. Line up the left front fender trim with the template, and attach it to the left front fender as shown.

5. While applying light pressure against the left front fender trim, carefully remove the taped adhesive backings. 6. Using a rubber roller, apply firm pressure against the left front fender trim and roll from one end to the other. Remove the template. NOTE: Apply firm pressure, especially at the ends. 7. Turn the template over, and repeat steps 1 through 6 for the other side. NOTE: • Be careful not to damage the body paint finish. • This kit should be installed only if the ambient air temperature is 60°F (15°C) or above. • To allow the adhesive to cure, do not wash the vehicle for 24 hours. Make sure the customer is aware of this.