Download 2019 Honda Accord Parking Sensors Installation Instructions – 1. Disconnect the negative cable from the battery. 2. Pull away the door opening seal, and remove the passenger’s dashboard side lid. 3. Remove the passenger’s dashboard under cover. 4. Open the glove box and remove the passenger’s trim panel. Close the glove box. 5. Remove the passenger’s outlet. 6. Remove the glove box, and unplug the vehicle connectors (if equipped). 7. Remove the passenger’s door sill trim. 8. Pull away the door opening seal, and remove the passenger’s kick panel.
9. Release and pull up on the rear seat cushion. Place a piece of masking tape as shown to prevent the hook from re-engaging. 10. Remove the right rear door sill trim. 11. Remove the right B-pillar lower trim. 12. Remove the right seat side bolster. 13. Pull away the door opening seal from around the right C-pillar upper trim. 14. Using a rubber mallet wrapped with a shop towel, lightly tap the area marked “SIDE CURTAIN AIRBAG” on the right C-pillar upper trim to push in the clip. Make sure to strike the area perpendicular to the vehicle.